摘要
在钻完井过程中,水平井下套管至水平段遇阻卡情况普遍存在,极端情况甚至出现套管卡死的现象。川西地区地质情况较为复杂,水平井下套管难度大,复杂情况多。本文通过对多口典型井下套管遇阻情况和原因进行分析,得出套管遇阻卡情况主要分为:突然遇阻和阻力渐增导致阻卡两种情况,并针对这两种情况提出了相应的改进措施。
During the drilling and well completion process,sticking often occurs when casing is run into the horizontal section during RIH of casing,and in some extreme cases casing may be tightly stuck.It is much more serious in western Sichuan due to relatively complex geological conditions.Analysis of some typical sticking cases and their causes leads to the following conclusion:there are 2 main types of sticking:sudden sticking and sticking due to increasing resistance;and the relevant improvement measures are put forward.
引文
[1]秦永和.大港油田大位移井钻井实践和技术最新进展[J].石油钻探技术,2006,34(4):30-33.
[2]高德利.南海西江大位移井完井工艺分析研究[J].石油钻采工艺,2004,26(3):1-6.
[3]郑传奎.大位移井减阻工具合理安放位置研究[J].天然气工业,2007,27(3):66-68.
[4]王仲茂,李文阳.油田注水开发区套管变形机理及预防[J].石油钻采工艺,1989,9(2):11-22.
[5]何世明,郭小阳,徐璧华,等.水平井下套管摩阻分析计算[J].西南石油学院学报,1997,(2):29-34.
[6]王建军,张绍槐.水平井套管摩阻解析分析[J].西安石油学院学报,1996,11(6):17-19.
[7]李克向.钻井手册(甲方)[M].北京:石油工业出版社,1990:385-388.
[8]王艳红.水平井完井管柱可下入性分析研究[D].山东东营:中国石油大学(华东),2008.
[9]张凯敏.水平井下套管摩阻研究[D].四川成都:西南石油大学,2014.
[10]蔡恩宏.弯曲井段种套管通过能力分析研究[J].石油与化工设备,2010,13(8):15-17.